SIMPLE LINK - UNO
Column to emitter link made simple
Provides voltage to the electrospray and connects the column and emitter with an accessible Zero Dead Volume fitting
Ergonomic tool-free operation, reduces complexity and chances of error.
Comes in two versions: SIMPLE LINK UNO-16 for VICI™ (1/16 OD sleeve, 13 nl swept volume) and SIMPLE LINK UNO-32 for VICI™ (1/32 sleeve, 1 nl swept volume) fittings.
Compatible with Nano Flex™
Recommended emitters: Sharp Singularity 7.5cm long
SIMPLE LINK UNO-1/32”
FAQs:
- 1) Parts included in the package for the Simple Link Uno-16
The fitting assembly incorporating:
A VICI™ 1/16” to 360 reducing union with 150 um ID bore, clamped into a PET housing so that it can be tightened without tools.
a PEEK 360 um pre-assembled nut and ferrule with a PET finger-tight handle for the emitter side
a 1/32” Stainless Steel nut and a PEEK ferrule assembly with a PET finger-tight handle for the column side
two Teflon sleeves for the column side: 1/16" OD; the IDs are 380 um for 365 um OD columns, and 300 um ID for 280 OD columns.
The simple link body
2) Parts included in the package for the Simple Link Uno-32
The fitting assembly incorporating:
a VICI™ 1/32" to 360 reducing union with 50 um ID bore, clamped into a PET housing so that it can be tightened without tools.
a PEEK 360 um pre-assembled nut and ferrule with a PET finger-tight handle for the emitter side
a 1/32” Stainless Steel nut and a PEEK ferrule assembly with a PET finger-tight handle for the column side
two peek sleeves for the column side: 1/32" OD; the IDs are 380 um for 365 um OD columns, and 300 um ID for 280 OD columns.
The simple link body
3) Is the SimLinkUno-16 compatible with Thermo™ nanoViper™ connector?
The VICI™ 1/16” to 360 has a thread compatible with the nanoViper™, and it is flat at its end, so it provides a good surface for the connector to fit and press tight. Because parts are produced by different providers, it is not possible to ensure that the VICI™ 1/16” to 360 - nanoViper™ assembly will withstand the pressure specified by each manufacturer independently. The short answer is: Yes, but with a disclaimer on maximum pressure. Having said that, this should not be a problem because the pressure at the emitter to column interface is very low.
4) Is the SimLinkUno-32 compatible with Thermo™ nanoViper™ connector?
No